Nixer RP64 EQ 1U 19in Rack Mount AoIP Patch inc 3 band EQs and Limiters
Model: NIX00658EQ
About: Nixer RP64 EQ 1U 19in Rack Mount AoIP Patch inc 3 band EQs and Limiters
Based on the latest Nixer audio processor, the RP64 EQ is a 64 input to 64 output digital Audio over IP 'patch' panel. Using an intuitive interface, it is possible to connect any input to any output. This facilitates the quick and easy repatching of critical signals without the need of having to use a laptop and Dante Controller and the inherent delays this brings. Any input can also be routed to multiple outputs simultaneously. The RP64 EQ patching reconnection is near instantaneous. In addition to this each input stream has three band EQ, Level control and Limiter. There is an AES input, AES output and a Stereo Line Output.
Key Features
- Simple and Intuitive Operation to rapidly route critical signals from a dedicated operator/engineering position in the event of equipment failure
- 64 inputs, 64 outputs (@ 48kHz)
- Three band EQ per input, Level Control and Limiter
- AES input, AES output plus Stereo Line Output
- No external laptop and cumbersome software patching
- Near instantaneous audio switching
- Large colour LCD touchscreen for quick and easy re-patching of critical signals
- Reset and recall route status from memory
- Compact 1RU design (less than 120mm deep) for deployment in any frame, desk or custom location
- PoE power or via external DC input for power redundancy
- Primary and Secondary network ports
- OSC control via RJ45 (under development, contact Sales for further information).
3 base configurations
- RP64 - 64 input, 64 output patch unit, front panel display
- RP64 EQ - 66 inputs with 2 band EQ, 68 output patch unit, front panel display, stereo line out and AES I/O
- RP64 CV2 - 66 inputs with 2 band EQ, 68 output patch unit, no front panel display, stereo line out and AES I/O
Power to the RP64 can be either via PoE on the Primary RJ45 port and/or via the 24V DC power input. Using both PoE and the DC input enables power redundancy. Also, on the rear panel there is a secondary RJ45 port for either redundant or switched AoIP connections. In addition to this there is a Control port for controlling the RP64 via OSC and a Remote RJ45 port for use with optional hardware remotes.