APC Power-Saving Back-UPS Pro 1500

About: APC Power-Saving Back-UPS Pro 1500

The Back-UPS Pro 1500 by APC is a High Performance Computer and Electronics UPS for Premium Power Protection

Includes : USB cable , User Manual

Safety-agency approved

Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.

USB connection

Use your PC to access additional power protection and management features for your UPS via a USB Port.

Disconnected battery notification

Warns when a battery is not available to provide backup power.

Audible alarms

Provides notification of changing utility power and UPS power conditions

LCD Status Display

Provides key UPS status at a glance. Multiple status indicators with load and battery bar graphs.

Resettable circuit breaker

Easy recovery from overloads; no need to replace a fuse.

Simple battery replacement

Increases UPS availability by allowing quick, easy battery replacement.

Surge only outlets

Protect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.

Battery and surge protected outlets

Back up and protect your hardware and data during power outages, surges and spikes.

Dataline surge protection

Provides protection of connected equipment from power surges on the data lines.

Cold-start capable

Provides temporary battery power when the utility power is out.

Battery failure notification

Provides early-warning fault analysis on batteries enabling timely preventive maintenance

Automatic self-test

Periodic battery self-test ensures early detection of a battery that needs to be replaced.

Boost and Trim Automatic Voltage Regulation (AVR)

Gives higher application availability by correcting low and high voltage conditions without using the battery (not available on all models).

Energy Management Function

Energy saving feature automatically power off peripherals when the a master device, usually a PC, hibernates or is shut down. Power to peripherals is immediately restored when the master device wakes up or is switched on.

Transformer-block spaced outlets

Protect equipment with input transformer blocks without blocking access to other receptacles.

Customizable voltage-transfer points

Adjust the voltage points (widen or tighten the range) where your UPS transfers to battery to maximize useful battery life and protect sensitive electronics.

Green mode

Patent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.

Intelligent battery management

Maximizes battery performance, life, and reliability through intelligent, precision charging.

Customizable voltage sensitivity

Toggle between pre-determined voltage-transfer points depending on your power quality (high, medium or low sensitivity), maximizing useful battery life and protecting sensitive electronics.

LCD Status Display

Provides key UPS status at a glance. Multiple status indicators with load and battery bar graphs.

Battery-protected and surge-only outlets

Reserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipment

Boost Automatic Voltage Regulation (AVR)

Preserves battery life and maximizes runtime by correcting low voltages without discharging the battery.

Green mode

Patent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.

Energy Management Function

Energy saving feature automatically power off peripherals when the a master device, usually a PC, hibernates or is shut down. Power to peripherals is immediately restored when the master device wakes up or is switched on.