Earthworks FlexWand FW730 Cardioid Microphone w/ Boom & Stand

About: Earthworks FlexWand FW730 Cardioid Microphone w/ Boom & Stand

The Earthworks FlexWand is a combination of a 30kHz High Definition Microphone and a low profile microphone stand and boom as a single unit. It allows the microphone head to be positioned as high as 7 feet and as low as 1.5 feet from the floor or anywhere in between. There are no visible wires or cables above floor level. Visually it is low profile, smooth, sleek and clean. The FlexWand is the ideal solution for applications where the utmost in sound quality and a low profile is required. Now you don’t have to find a mic, attach the mic clip to the stand and then dress the cable around the stand. Just pick up the FlexWand, position it and plug the mic cable into the base.

• Uniform frequency response on or off axis
• Frequency response of 30Hz to 30kHz
• Near perfect polar response and the ability to reject sounds from the rear of the microphone, making it a perfect solution for choirs and vocal groups
• Large flex section near the center of the stand that couples the stand and the wand
• Mini-gooseneck between the end of the wand and the microphone head
• Substantial improvement in gain before feedback
• They will handle high sound pressure levels with high rejection of sounds to the rear of the microphone
• Ideal where bands or orchestras are placed in front of a choir, as the FlexWand will reject much of the sound of the band or orchestra
• The near perfect polar response of the FlexWand allows the use of fewer microphones on choir, with better sound quality, no spotlighting and incredible rejection of sounds from the rear of the microphone
• The sturdy 12 pound cast iron base will not allow the FlexWand to be accidentally knocked over

Choir Miking Made Simple.

Integrated choir miking system with 30kHz cardioid microphone, low profile microphone stand and boom.

Unflinching Focus

A near-perfect cardioid polar pattern, with 32dB of rear rejection.

Less is Truly More

A wide coverage area means fewer mics and no spotlighting. Your choir will be heard as one unified voice.

Fully Flexible

The microphone head can be positioned as high as 7 feet and as low as 1.5 feet from the floor. Plus, the microphone cable plugs into the base of the microphone, making it incredibly low profile and clean.

Options

The FlexWand microphones have cast iron or tripod base options. Available in cardioid or hypercardioid. Matched pairs available.

Specifications

• FREQUENCY RESPONSE - 20Hz – 30kHz
• POLAR PATTERN - Cardioid
• SENSITIVITY - 10mV/Pa (-40dBV/Pa)
• POWER REQUIREMENTS - 24-48V Phantom, 10mA
• SIGNAL TO NOISE RATIO - 78dB (A-weighted)
• PEAK ACOUSTIC INPUT - 145dB SPL
• OUTPUT - XLR (pin 2+)
• OUTPUT IMPEDANCE - 65Ω balanced (between pins 2 & 3)
• MIN OUTPUT LOAD - 600Ω between pins 2 & 3
• SELF NOISE - 20dB SPL equivalent (A weighted)
• DIMENSIONS - Stand 7’ 2” long (2.18m), Base 12” (30.5cm) in diameter, (2.7cm) high
• POSITIONING RANGE - From 1′ 6″ to 7′ above floor level
• WEIGHT - Stand 2 lbs. (.9 kg), Base 12.6 lbs. (5.7kg)

What's Included

• 1x FlexWand Stand/Wand Section

• 1x Microphone Windscreen

• 1x Base for Stand/Wand Section