Genelec 8361A 3-Way Digital Nearfield SAM Studio Monitor (Each) - Grey

About: Genelec 8361A 3-Way Digital Nearfield SAM Studio Monitor (Each) - Grey

The flagship of The Ones range, the 8361A SAM Studio Monitor offers the most advanced acoustic performance of any studio monitor on the planet.

• Networked Smart Active Monitor (SAM) Systems feature automatic calibration to the environment.
• Minimum Diffraction Coaxial (MDC) Driver Technology reproduces outstanding sound image.
• Minimum Diffraction Enclosure (MDE) for uncoloured sound reproduction.
• Directivity Control Waveguide (DCW) for flat on and off-axis response.
• Acoustically Concealed Woofers (ACW) for controlled directivity down to low frequencies.
• Sophisticated drive unit protection circuitry for safe operation.
• Each transducer is driven by its own optimised amplifier.
• Advanced reflex port design for extended low frequency response.
• Intelligent Signal Sensing (ISS) for power consumption reduction in stand-by mode.
• Active crossover operating at low signal levels.
• Vibration decoupling Iso-Pod stand improves sound image definition.
• Versatile mounting options for all installation needs.
• Precise room response compensation for optimizing in-room performance.

An exquisite monitoring experience

The largest of our coaxial point source monitors, the 8361A offers extremely high dynamic range, unrivalled directivity and imaging and a short term SPL of 118 dB, enabling it to deliver an exquisite monitoring experience at any listening distance up to 5 metres – and therefore making it perfect for small to medium sized rooms.

Adapts to your space

The 8361A promotes faster and more consistent decision making, and also allows you to work reliably on longer sessions - because unnatural imaging, a main contributor to listener fatigue, is minimised. And by using it in conjunction with our powerful GLM calibration software, the 8361A will adapt to your acoustic space - compensating for any detrimental room influences and helping you produce mixes that translate perfectly, from stereo through to highly complex immersive formats.

Specifications

• Lower cut-off frequency, –6 dB - < 30 Hz
• Upper cut-off frequency, –6 dB - > 43 kHz
• Accuracy of frequency response, ± 1.5 dB - 36 Hz – 20 kHz
• Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz at 1 m - ≥ 118 dB SPL
• Maximum long term RMS acoustic output in the same conditions with IEC weighted noise (limited by driver protection circuit) at 1 m - 109 dB SPL
• Maximum peak acoustic output per pair in a listening room with music material at 1 m - 128 dB SPL
• Self generated noise level in free space at 1 m on axis (A-weighted) - ≤ 5 dB
• Harmonic distortion at 95 dB SPL at 1 m on axis
  • Freq: 50…100 Hz - < 3 %
  • > 100 Hz - < 0.5 %
• Drivers
  • Bass - Dual 263 x 137 mm (103/8 x 53/8 in) obround cones
  • Midrange - 130 mm (5 in) cone (coaxial)
  • Treble - 25 mm (1 in) metal dome (coaxial)
• Amplifier
  • Bass amplifier short term output power - 700 W
  • Midrange amplifier short term output power - 150 W
  • Treble amplifier short term output power - 150 W
    • (Long term output power is limited by driver protection circuitry)
  • Amplifier system THD at nominal output - <0.05%
  • Mains voltage - 100-240 VAC 50/60 Hz
  • Power consumption
    • ISS active - < 1.5 W
    • Idle - 20 W
    • Full output (short term) - 600 W
• Signal Processing
  • Analog signal input connector XLR female, balanced 10 kOhm
    • pin 1 gnd
    • pin 2 non-inverting
    • pin 3 inverting
  • Maximum analog input signal - +25.0 dBu
  • Analog input sensitivity (100 dB SPL at 1 m) - -6 dBu
  • Analog input sensitivity control - Adjustable from +36 to -6 dBu
  • Digital signal input connector XLR female 110 Ohm - AES/EBU Single Wire
  • Digital signal output / Thru connector XLR male 110 Ohm - AES/EBU Single Wire
  • Digital audio input
    • Word length - 16 - 24 bits
    • Sample rate - 32 - 192 kHz
  • Digital input sensitivity (100 dB SPL at 1 m) - -30 dBFS
  • Digital input maximum attenuation using DIP switches - 42 dB
  • Digital input maximum attenuation using GLM software - 120 dB
  • Input to output delay at high frequencies, linear phase, analog input - 4.2 ms
  • Input to output delay, analog input with ultra wide linear range - 8.6 ms
    • (When using the AES/EBU digital audio input, the system latency may differ slightly from the published value due to effects of the active sampling rate)
  • Control network
    • Type - Proprietary GLM network
    • Connection - 2 RJ45, CAT5 cables
  • Crossover frequencies
    • Bass/Mid - 320 Hz
    • Mid/Treble - 2800 Hz
  • GLMTM software frequency response adjustment
    • Parametric notch filters - 16
    • Shelving filters - 2 LF and 2 HF
  • System room response calibration - Genelec GLM AutoCal, GLMTM manual, Stand-alone
• Dimensions (HxWxD)
  • With IsoPod Stand - 23.35 x 14.06 x 13.66 inch (593 x 357 x 347 mm)
  • Without IsoPod Stand - 22.44 x 14.06 x 13.66 inch (570 x 357 x 347 mm)
• Weight - 70.33 lb (31.9 kg)

What's in the Box

• 1x 8361A monitor
• 1x mains cable 1,8 m
• 1x RJ45 cable 5 m
• 1x operating manual
• 1x The Ones brochure