Audient RM1 Reference Microphone

About: Audient RM1 Reference Microphone

The RM1 Reference Microphone is the measurement microphone for Audient’s RoomTune Monitor Correction. Each mic is individually calibrated, so every measurement RoomTune takes is accurate.

NOTE: Requires an Audient iDMK3 interface (iD1, iD2, iD2+ and iD4+)

• Individually calibrated, with a unique RM1 frequency response profile for accurate measurement every time
• MEMS capsule for consistent measurements over time
• Required for RoomTune Monitor Correction on every iDMK3 interface
• Automated setup that dials in gain, levels and phantom power, with no controls to set
• Accurate monitoring, so mixes translate from the studio to every other system

Why choose the RM1?

Studio microphones are designed to add character. That's what you want when recording, but it throws off a monitor correction measurement. The RM1 is built to hear your room exactly as it is, and RoomTune requires it to set up monitor correction. Keep it in your locker, and you can re-measure any time you move your monitors or change your room.

RoomTune is free software included with every iDMK3 interface. Every room changes what you hear, so a mix that sounds right at your desk can fall apart everywhere else. RoomTune corrects your monitors on your iDMK3 interface, so you hear your mix as it really is.

Audient designs the iDMK3 interface, the software and the microphone together, so RoomTune can configure the whole measurement itself and check for errors as it goes.

You place the mic. RoomTune does the rest.

During RoomTune setup, enter your RM1 serial number to load its RM1 frequency response profile. RoomTune then dials in phantom power, mic gain, monitor level and latency compensation automatically, with no controls for you to set. Easy.

One standard. Four interfaces.

Every iDMK3 interface shares the same Console Mic Preamps, 32-bit Conversion, Analogue Tone Suite and built-in RoomTune Monitor Correction. Choose the one built for the way you work.