Cloud BT-2F Bluetooth Wireless Audio Input Module - White

About: Cloud BT-2F Bluetooth Wireless Audio Input Module - White

BT-2F is a wall-mounting remote input module for use with Cloud products fitted with an RJ45 Facility Port. The BT-2 enables compatible portable devices such as laptops, tablets and smartphones to stream audio wirelessly into the installed zone.

• Remote Bluetooth input module for Cloud host units with RJ45 Facility Port Capability
• Easy connection to host unit via screened Cat 5 cable (up to 100m)
• Uses single-button Bluetooth “pairing” mode for secured operation
• Alternative “unsecured” mode: configurable at installation
• Bluetooth identifier (1-16 characters) may be set with external Windows utility application via USB connection
  • Application also allows audio level trim in 3 dB steps
• Micro USB Connection for plate naming
• Bicolour LED indicating connection progress and streaming activity
• May be daisy-chained to remote input modules (e.g., LM-2) in same Zone
• RSL-6 or RL-1 remote plates may be daisy-chained to BT-2
• Available in black and white

The BT-2 is exceptionally simple to install; the rear RJ45 connector is wired to one of the host unit’s Facility Ports with a single screened Cat 5 cable using standard shielded RJ45 connectors at each end. The Cat 5 cable carries DC power as well as balanced audio.

The BT-2 will route a mono sum (L+R) of the streamed audio to the host unit and is compatible with the following Cloud products which are fitted with RJ45 Facility Ports:

• Z4MK4 & Z8MK4 Zone Mixers
• 46-120MK2 & 46-240 Zone Mixing Amplifiers
• MA40F, MA40T and MA40E Mini Amplifiers
• MA80FT and MA80E Mini Amplifiers
• 46-80 and 46-80T Zone Mixing Amplifiers
• MPA120MK2 & MPA240MK2
• 24-120 & 24-240 Zone Mixing Amplifiers

If you do not wish the BT-2F to function as a single-zone priority input, you can use an FPA-1 adaptor to configure it as a global line input. This provides additional flexibility, allowing it to serve as a priority line input across multiple zones, depending on the headend functionality. For products not equipped with a Facility Port connector, an FPA-1 adaptor can be used per zone.