Menu

COVID-19 Alert: Curb-side pick up is now available for orders placed in advance. Please wear a mask. Showroom is still closed. Orders may be delayed due to higher volumes.

Free shipping on most orders over $199!*

Whirlwind ROK1- Remote Outlet Controller

Model: ROK1

Whirlwind ROK1- Remote Outlet Controller
Whirlwind ROK1- Remote Outlet Controller
Whirlwind ROK1- Remote Outlet Controller
  • Free Shipping on orders over $199
  • Not in-Stock: Estimated Lead Time 7-10 Days 
  • Not yet reviewed




About: Whirlwind ROK1- Remote Outlet Controller

The Whirlwind ROK1 Remote Outlet Controller allows a 20 Amp 120 VAC circuit to be turned on and off from a conveniently located switch or a programmable dry contact closure. The device is a single gang decora type design that can installed in a 3.5" deep box or combined with outlets in a multigang box located in a ceiling or wall.

A single pole relay makes and breaks the line or hot leg of a 20 Amp 120 VAC single phase circuit. The relay operates on 24 VDC which is generated internally. The device is activated by closing a single pole dry contact closure connected to the terminal block which completes the low voltage DC circuit through the relay coil.  Control circuit current flow is about 40 mA. A green power on LED illuminates when the ROK1 is turned on.

Installation
Single gang mounting of the ROK1 requires a 3.5" deep gangable type box or utility box with an extension ring. Multigang installation with outlets requires at least 2.5" depth behind the faceplate and wire entry should not be directly behind the ROK1.  The line side of the single phase power circuit connects to the LINE IN terminal and the load is connected to the LINE OUT terminal. Neutral and earth  connections are required but do not loop through the unit. Connect the circuit neutral and earth to the load connections first and tap off them to connect to the ROK1. The neutral is required for the 24 VDC supply circuit. Connections are spring cage type and will accept 12 AWG solid or stranded wire. Control wiring of 18 -24 AWG is acceptable and should be sized for the length of the control run.


Reviews: Whirlwind ROK1- Remote Outlet Controller

There are currently no product reviews.


Warranty: Whirlwind ROK1- Remote Outlet Controller

AVShop.ca Warranty:

30 Days

Manufacturer's Warranty:

Medusa/Custom:

  • Cables: 5 yrs.
  • Connect Series: 3 yrs.

US Audio / Digital Products:

  • All AC Powered Equipment: 5 yrs.

Imp Interface Boxes:

  • Passive: 3 yrs.
  • Active: 2 yrs.
  • EDB1: 90 days
  • Tester Boxes: 3 yrs.
  • MCT-7: 90 days
  • Q-Box: 1 yr.