ATA Molded PE Shock Rack w/ Rubber Shock Suspension; 12U
Lightweight polyethylene construction
Independent rubber shock absorbers at each corner
360 degree air ventilation around equipment
Threaded, field replaceable 7mm zinc-plated steel rack rails
Adjustable interior sliding support on each side of rack adjusts from to back and up and down for rear support of gear
Comfortable recessed side handles and locking lids
Heat-treated 10/32 rail bolts & washers included
Handles: 2 Carry
Latches: 4 Twist
Interior Length: 16.50"
Interior Width: 19.00"
Interior Height: 21.00"
Rackable Depth (to rear lid): 19.50"
Exterior Length: 22.75"
Exterior Width: 24.25"
Exterior Height: 26.00"
Exterior Weight: 34.00 pounds
AVShop.ca is a Canadian authorized Gator
There are currently no product reviews.
We are proud of Gator products and want you to be proud to use them. If there is any defect, we will be happy to replace or repair it for you.
Warranty covers Gator products only. We cannot be held responsible for any gear damaged while in Gator cases. Gator does not provide specs for
maximum weight allowable per case. Common sense applies! Warranty does not cover cases damaged by weight of contents!
The warranty is good for the first owner and will cover any damages or problems that occur through the normal use of the product. Unfortunately, this does
not cover thing like using your case as a speed bump, tossing it from high buildings, or leaving it outside during a hurricane.